Page 1 of 1
Making a motise and tenon neck
Posted: Thu Dec 22, 2011 8:56 pm
by admin
Post your procedure for making the mating parts
Re: Making a motise and tenon neck
Posted: Wed Aug 15, 2012 1:46 pm
by Dave Bagwill
Somebody needs to step up and post their procedures! I need them! :-)
Re: Making a motise and tenon neck
Posted: Wed Aug 15, 2012 2:57 pm
by ken cierp
Jonathan Kinkead's book has simple to make mortise and tenon jigs. I also saw a system where the neck block mortise was cut on a table saw with a dado blade, you can rabbet a whole strip of blocks in one pass. Then you cross cut the blocks short of final height then glue on a cap to reach the final dimension --- pretty slick!