Needing Advice-My first Acoustic Neck

[Kim Hillard]

John and Ken, I
I appreciate the feedback. I'll work on it from this end. I can click the links to each of the three photos and each one comes up fine on my phone. This is just a learning curve on my end I'm afraid.
Best regards,
Kim

[ken cierp]

Google "how to post images on PHPBB forums"

Lots of options

[ken cierp]

Without pictures I can't offer informed advice, but generally a board like that is slab cut. So the lamination is made with book matched pieces to get the best vertical grain convergence pattern. Adding a contrasting stripe will look nice. Forget the scarf joint. Make your billet/blank about 25x4x4

[Kim Hillard]

Ken, you are doing a marvelous job of keeping me updated and I'm slowly working through your suggestions. I am grateful for you sticking with me.
I'm trainable most times.

[Kim Hillard]

Ken, as you can see in my Attached photos (I hope they are there now) that your assumption is spot on. The board is slab sawn and I have enough width to make a mirror image for lamination with a third contrasting stripe.

[Tim Benware]

By my calculation you should easily get 3 necks from that piece.

[Kim Hillard]

Tim, I'd be content to just get one and move my project along.