I made me a double sided radius dish on Saturday. Used the radius rails and router method. Worked pretty good. I glued two 3/4" MDF 24" rounds together.
I see I still have some router bit marks to sand out, but I think it turned out okay and for minimal cost. 15' and 30' is what I use.
I forgot to take pics of the process/mess but you already know the basic routine I think.
Kevin
Radius dishes
-
Tim Benware
- Posts: 1489
- Joined: Thu Dec 22, 2011 1:22 pm
- Location: Asheboro, NC
-
Kevin in California
- Posts: 2796
- Joined: Mon Dec 19, 2011 4:19 pm
Re: Radius dishes
It was VERY messy but I set up a table outside in the driveway and made the mess there, then vacuumed it up when I was done.
I'm thinking about making another set. I need an narrower set that will fit in my go-bar deck as I only have about 21 inches between my supports so I cut them down to fit after they are routed out.
I'm thinking about making another set. I need an narrower set that will fit in my go-bar deck as I only have about 21 inches between my supports so I cut them down to fit after they are routed out.
Re: Radius dishes
http://forum.ukuleleunderground.com/sho ... adius-Dish
How about this for making a dish.
Tom
h l a
e d n
How about this for making a dish.
Tom
h l a
e d n
"The person who has never made a mistake has never made anything"