Page 1 of 1
Economy Bridge Pin Hole Reamer
Posted: Sat Dec 24, 2011 2:40 pm
by Tim Benware
Made from the cut off of a file (Nicholson in this case) ground to 5 degree. The edge bites real well to clean thin shavings off.
Re: Economy Bridge Pin Hole Reamer
Posted: Sat Dec 24, 2011 4:06 pm
by Dave Bagwill
A good tip.Thanks!
And nice photobucket usage ;-)
Re: Economy Bridge Pin Hole Reamer
Posted: Sat Dec 21, 2013 4:26 pm
by Tom West
I have done this but with the hard part of the file. I just assumed the tangs were too soft to make a cutting edge. Most tangs bend very easily.
Tom