Page 1 of 1
So I made a downdraft table out of odds 'n ends
Posted: Wed Jul 25, 2018 4:47 pm
by Dave Bagwill
Eaasy to make, scrap matl's, works just fine.
I use the little belt-mounted remote so's I can keep the shop-vac on the other side of the door.
Re: So I made a downdraft table out of scrap
Posted: Wed Jul 25, 2018 5:05 pm
by Dave Bagwill
Underneath
Re: So I made a downdraft table out of odds 'n ends
Posted: Wed Jul 25, 2018 10:06 pm
by Kevin in California
Nice Dave. I should do something like that since i took the air cleaner out of the shop.
Re: So I made a downdraft table out of odds 'n ends
Posted: Thu Jul 26, 2018 4:16 pm
by Tim Benware
Nice Dave. I've had the plans for one of these for years with the intent of making one and never got around to it. With my slow down now due to wife's retirement and or travel schedule i doubt it will get done.
Re: So I made a downdraft table out of odds 'n ends
Posted: Fri Jul 27, 2018 12:23 am
by Dave Bagwill
What I can't do is caulk worth a damn....always sloppy.
Re: So I made a downdraft table out of odds 'n ends
Posted: Mon Jul 30, 2018 8:11 pm
by Dave Bagwill
Haven't been able to use the shop for over a week. Medford, Oregon is surrounded by fires - we are north of Redding Ca and all that smoke comes to roost in our Rogue Valley (Medford) - last week Medford had the worst air quality in America. Made one's lungs hurt to be outside for any length of time.
My shop, alas, is not 'tight' so is no barrier to the smoke.
Or the 105 F temps.
Re: So I made a downdraft table out of odds 'n ends
Posted: Tue Jul 31, 2018 10:53 am
by Kevin in California
Dave in our valley were are getting smoke from the Ferguson fire in Mariposa county. I can only imagine how bad it is there from the Carr fire.