Page 1 of 1
While I was making a bridge for my current build
Posted: Thu Jul 20, 2017 10:53 am
by Kevin in California
I thought, hey while I have all the equipment set up, why not rough out a few bridges so I won't have to set this up again for awhile.
So I made 4 ebony, 2 indian rosewood, 5 walnut, and 2 olive bridges. The thicknesses vary slightly, but most are a bit over 3/8" so I can bring them down a little if necessary.
This is the first time I've made them up ahead of time. Anyway, thought I'd share.
Re: While I was making a bridge for my current build
Posted: Thu Jul 20, 2017 8:28 pm
by John Link
Love the way you pack it into your shop.
Re: While I was making a bridge for my current build
Posted: Fri Jul 21, 2017 12:41 am
by Kevin in California
For sure it is packed in there John. Wish I had the luxury of a big dedicated shop. But it works!!!
Re: While I was making a bridge for my current build
Posted: Sat Jul 22, 2017 2:39 pm
by Herman
Kevin, look again. You have a big shop. Wanna swap with mine?
Herman
Re: While I was making a bridge for my current build
Posted: Sun Jul 23, 2017 12:54 am
by Kevin in California
Yes Herman I know, and it just goes to show that even big guys can have a little one and make it work!
Re: While I was making a bridge for my current build
Posted: Sun Jul 23, 2017 6:57 am
by Dave Bagwill
Oh, THAT was almost below the belt......wish I'd said it...
All in good fun.
Re: While I was making a bridge for my current build
Posted: Mon Jul 24, 2017 10:47 am
by Herman
Maybe little but very functional. ask around.
Herman