Page 1 of 1
Bending 1/4" all-thread
Posted: Sun Apr 03, 2016 4:17 pm
by Dave Bagwill
Before I go out and buy a 3' length - can this stuff - 1/4" all-thread - be bent at a right angle, using a vise?
Re: Bending 1/4" all-thread
Posted: Sun Apr 03, 2016 4:41 pm
by ken cierp
50/50 it will snap off in a tight bend -- I think if you got it hot enough to start the bend with very little force you'd be OK.
Re: Bending 1/4" all-thread
Posted: Sun Apr 03, 2016 5:32 pm
by Dave Bagwill
Ok, thanks.
Re: Bending 1/4" all-thread
Posted: Mon Apr 04, 2016 6:48 am
by Herman
Heat! Torch!
Re: Bending 1/4" all-thread
Posted: Mon Apr 04, 2016 9:11 am
by Jim Ebert
Red Hot!
Re: Bending 1/4" all-thread
Posted: Mon Apr 04, 2016 12:08 pm
by Dave Bagwill
Not my hair dryer? :-)