Page 1 of 1
Kerfed lining jig works great
Posted: Thu Feb 04, 2016 12:09 am
by John J
Finished up this jig and did a whole bunch of kerfed linings in no time. Based on the frets.com jig referenced here by Ken and also additions from the anzlf site and a couple of my own.
Re: Kerfed lining jig works great
Posted: Thu Feb 04, 2016 1:23 am
by Dave Bagwill
That is quite the project and makes some nice-looking kerfing. How much do you charge?? :-)
Re: Kerfed lining jig works great
Posted: Thu Feb 04, 2016 12:26 pm
by Tim Benware
Is it advancing it automatically?
Re: Kerfed lining jig works great
Posted: Thu Feb 04, 2016 3:12 pm
by John J
Tim Benware wrote:Is it advancing it automatically?
Yes Tim, it advances to the kerf spacing you set stopping just before the blade cuts the lining. When you pull it back it resets and you push towards the blade, advancing each push. You can actually move along quite rapidly. Alas not motorized (at least not yet).