Rosette tool

[David L]

Here I am using my rosette channel cutting tool.

David L

[Dave Bagwill]

David - what kind of bit are you using in that Dremel?

[David L]

I am using a 3/32" downcut carbide. I figured what my OD was and kept shortening the ID of the cut little by little until I reached the desired width of the groove.

David L

[MarkAndrew1]

I am using a 3/32" downcut carbide. I figured what my OD was and kept shortening the ID of the cut little by little until I reached the desired width of the groove.

David L

I just ordered the same router base and circle cutter jig. Do you
think using the 3/32 bit is a good one to start with? This will be
my first rosette. i'm just doing a 3mm abalone ring. I also
plan on practicing with mdf.

Any advice?

[ken cierp]

Down spiral you will not be sorry!

Here's the base fixture knock off


viewtopic.php?f=7&t=15

[MarkAndrew1]

Down spiral you will not be sorry!

Here's the base fixture knock off


viewtopic.php?f=7&t=15

I will definitely get the down cut spiral bit. I think Rockler and Woodcraft have them.

[ken cierp]

We get ours from here:

https://www.drillbitcity.com/catalogue/ ... _tools.asp

I believe they sell single bits as well