Page 1 of 7
KMG 000 First Build
Posted: Tue Feb 24, 2015 12:36 pm
by John J
Hello all. John from St Paul Minnesota getting started on my first foray into what I hope is a new addiction. I finally got all my stuff and got moving. The fmold went together nicely. Got sides measured and cut (my first moment of nerves). Neck and tail block glued. Linings and reinforcements done. Next step is contouring back and top. Having a blast. Look forward to any and all comments/advice.
Re: KMG 000 First Build
Posted: Tue Feb 24, 2015 12:40 pm
by Dave Bagwill
Greetings John! You're off to a great start - we love the pix, for sure.
Re: KMG 000 First Build
Posted: Wed Feb 25, 2015 1:05 am
by John J
Contouring the top edge. Followed Ken's instructions and it came out very nice.
Re: KMG 000 First Build
Posted: Wed Feb 25, 2015 2:39 pm
by John J
Contoured the top and back rim. Looks good I think. When I set the back on it there is the gap at the neck block area that I hope looks right. When I push down it fits tight all the way around.
Re: KMG 000 First Build
Posted: Wed Feb 25, 2015 2:44 pm
by Dave Bagwill
That looks right, JohnJ. Good work.
Re: KMG 000 First Build
Posted: Wed Feb 25, 2015 8:20 pm
by John J
Wasn't too sure about how to do the rosette. I think this will work.
Re: KMG 000 First Build
Posted: Wed Feb 25, 2015 8:28 pm
by Daniel P
Welcome to the forum - looking good so far.