Because of the timing, wanting to apply several coats of finish per day at intervals and trying to get them done in time for Christmas, it wasn't practical for my nephew to come over and do the finishing on his so I did the finish on both of them together. I did the soundboards in French polish with U-Beaut hard shellac. We then polished them by hand, which took quite a while to get a decent sheen and my arm was pretty sore afterward so I promptly ordered a buffer for next time!
I finished the backs, sides and necks in Tru-oil with a satin finish that hopefully won't show the "dings" as much (one of these is for a 13-year-old after all). I used a cherry backstrip to separate the two halves of the back so the reversing grain pattern of the curly maple doesn't clash at the center.
My nephew and his wife recently bought a house with a wooded lot. I spotted a small rotting maple stump in his woods and said "hey, there's guitar parts in that stump!" We resawed the stump into veneer about 1/8 inch thick and dried it, then cut a bunch of rosette segments from it. The rosettes each have 9 segments and I made a plexiglass form just to hold them in a circle for visualization, then we spread out all the segments we'd cut and let the recipients design their own rosettes by arranging the segments as they liked. When finishing them I intentionally left some of the worm holes in the spalted wood rather than filling them in, as I think it gives them a nice earthy character.
I used the same elliptical bridge design that I created for my first guitar, but I carefully tweaked the dimensions and shaved it down to only 14 grams plus about 4 grams for the saddle. It still maintains the same 49 cm gluing area and is just wide enough to get the shoulders over the X braces underneath. As with my first guitar I angled the grain of the bridge at about 30 degrees from horizontal and angled the grain of the bridge plates underneath in the opposite direction.
This was my first time doing shell inlay other than simple dots, and I created the dragonfly design from a photograph I took many years ago. I cut the inlay pocket and the shell on my CNC router and after a few tries on scrap wood I got a pretty decent fit. With the light curly maple headplate there's no easy way to hide gaps like one could on a darker wood. The wings are paua abalone and I cut the body from black mother of pearl for contrast.
My grand niece has been learning to play on a borrowed baby Taylor (decent but low-end) and my nephew's wife hasn't had one of her own before so this is the first guitar each of them has owned. We delivered the guitars on Christmas day and they were both delighted!
