Page 2 of 2
Re: How to do it??
Posted: Mon Sep 07, 2020 11:14 pm
by Dave Bagwill
I reckon I'll mock up a headpiece out of some pine or such, and give it a whirl before digging into the real thing.
Best way to drill the the tuner holes? The tuners are individual, not 3-on-a-plate.
Re: How to do it??
Posted: Tue Sep 08, 2020 2:24 pm
by Carl Dickinson
I use a doweling jig that clamps on the side of the headpiece to do that.
Re: How to do it??
Posted: Tue Sep 08, 2020 3:02 pm
by Dave Bagwill
Re: How to do it??
Posted: Wed Sep 09, 2020 7:59 am
by Kenny Wiebusch
I did not have a jig. I used a level and a drill press with a vice.
Re: How to do it??
Posted: Tue Sep 15, 2020 4:24 pm
by Kevin in California
Dave
This is how you do it.
Drill your tuner holes in the side first, then use a template and a drill rod cut at 45 degrees and sharpened to follow the template and cut your slots....you go down about 1/8" at the most per pass.
See the pics
