a hard piece of Maple

dimensional parameters, brace designs, brace layout and the logic behind those choices
Post Reply
Dave Bagwill
Posts: 5955
Joined: Tue Dec 13, 2011 7:44 pm

Re: a hard piece of Maple

Post by Dave Bagwill » Wed Dec 10, 2014 5:00 pm

Does anyone here know what the final back thickness would normally be, right before finishing?
-Under permanent construction
Top
Tim Benware
Posts: 1489
Joined: Thu Dec 22, 2011 1:22 pm
Location: Asheboro, NC

Re: a hard piece of Maple

Post by Tim Benware » Wed Dec 10, 2014 6:05 pm

ken cierp wrote:Anything other than Zirconia grade abrasive on a drum sander will be a disappointment

We use this

http://www.woodworkingshop.com/product/pe68080/
Exact same stuff I use. Love the markings on the back that make it so easy to cut the right length piece. Can't be beat.
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Top
Post Reply

Return to “Guitar Backs”