Acoustic Guitar Construction

The body is 91.8 and the neck is 88.7

Beau J wrote:The body is 91.8 and the neck is 88.7

91.8 + 88.7 = 180.5. You are 0.5 off. This is like starting off needing a neck reset. I think Ken has a tutorial on how to sand the top down and feather in the sides to achieve the 91.3* angle you need for the top or you can floss the heels to achieve a 88.2* on the neck. I use "ACE" to get there that is:

A = neck angle
C = Center line
E = Elevation

Get the angle on your neck first, get the proper center line, then lower the tenon into the mortise. You may find when you get close you'll need to use shims to get a tight fit because the angle is so far off. I'm not sure how much the top would need to be sanded for the other method or if a combination approach is appropriate.

Tim --- Beau

In this case sanding anything off the sound board will make matters worse. The level across the sound board/neck plane indicates that the neck is tipped upward leaning toward the sound board. This as Tim mentioned is indeed a repair operation. The key at this point is to get the heel cheeks shaved (bottom up) so the neck tilts back until the level lays flat along the full length The Straight Line -- you cannot be concerned at this phase as to how the dove tail fits it certainly will be very loose. Once you have the straight line and the neck aimed on center, you can go about the business of shimming the dove tail tenon and or mortise to make it tight. The two others guys that were posting their problem I suspect failed to grasp this requirement and I believe it lend to some long term grief.

Again, I have not seen or read a better dove tail joint shimming/sanding procedure than that found in Bill Cory's book.

Since your angle is a little steep some adjustment in bridge thickness and saddle height may be necessary but that is not a big deal and frankly is often over looked and not taken into consideration as one of the controlable neck set variables.

""The two others guys that that were posting their problem failed to grasp this requirement ""


I may have been one of the two other guys but I now have one of the nicest sounding guitars ever build in my opinion LOL

I did have the same problems but got great advise on the forums and stuck with it until I overcame them.

Dont give Up !!

Rusty -- Good to hear it worked out for you, how's the action/playabilty on that guitar?

kencierp wrote:Rusty -- Good to hear it worked out for you, how's the action/playabilty on that guitar?

All Good Ken, I know it was a nightmare at the time and I was close to packing it in but it was definitely worth it. I gave it to my son as a Xmas present and believe me he would have told me long ago if it was not right as he is a good guitarist himself. No complaints so far.

Thanks again for all the advise---looking forward to my mega mold arriving someday soon and then things will really start to fly around here !!


Regards from Ireland
Rusty


{ Kevin }