Page 6 of 16

Re: Bearing RPM

Posted: Mon Nov 04, 2013 11:12 am
by Lonnie B
Thanks fellas the basket was her idea. But a good one. She says now if she had some Jimmie Johnson stickers to put on her walker. I'll have to check the Nascar store online. She appreciates the concern yu fellows show. Today I have to leave her alone for an hour or so as I run to another town to get an oven element that decided to go out.

Re: Bearing RPM

Posted: Sun Nov 10, 2013 4:06 pm
by Lonnie B
Hi guys wanted to give an update on my girl. She has made lots of progress. Gets around a lot easier. Goes back to visit the Dr who did the surgery tomorrow. She's in fine spirits,watching lots of TV :0) I think she'll be ok. Thanks to everyone who offered their good wishes. Really made her feel better at a very tough time of her life. My thanks guys

Re: Bearing RPM

Posted: Mon Nov 11, 2013 11:08 am
by Ray Ussery
That's great news Lonnie, and U train well... :>)

Re: Bearing RPM

Posted: Mon Nov 11, 2013 12:38 pm
by Lonnie B
Yes she's seeing the Dr now.

Re: Bearing RPM

Posted: Mon Nov 11, 2013 12:52 pm
by Lonnie B
Very good report. The Dr is very happy. Going to let her bend her knee just a little. No more then 45 degrees however. X-rays says good bone alignment. All in all a very successful visit. I'm very happy for her she's been a real trooper through all of this and I'm very proud of her.

Re: Bearing RPM

Posted: Thu Nov 14, 2013 5:53 pm
by Lonnie B
Had to take Carol to the Dentist today. She's getting around pretty good now.
Sooooo I took the next step on my Thickness Sander. I laminated the Formica to the Table Frame this afternoon. It has been on hold since my wife's accident. But luckily she's doing much better so I can get back to the business as usual. Tomorrow I'll move onto the next step which is constructing the frame itself. I'm not reading ahead on this project as I want to concentrate on just the one part. I have every confidence it'll all come together in the end. Then I can begin construction on my Guitar build.

Re: Bearing RPM

Posted: Thu Nov 14, 2013 7:37 pm
by Dave Bagwill
Faaaaar out!! (I'm channeling John Denver now I guess :-))