Steve's KMG 000-12 kit

ken cierp · Post by **ken cierp** » Thu May 22, 2014 7:55 pm

again hard to tell from 1000 miles away -- but it does look like you could take a hair off the heel cheeks to get it more snugged up with out screwing up the FB plane angle.

Dave Bagwill · Post by **Dave Bagwill** » Thu May 22, 2014 7:56 pm

Dang it, it is worth a try!!! Thanks. Everything else looks just fine; I'm thinking the block may be the culprit.

Dave Bagwill · Post by **Dave Bagwill** » Thu May 22, 2014 8:49 pm

Okay, all is well. :-) I did shave a tiny bit off the cheeks, then did some judicious but aggressive flossing and it is coming along just right.
Thanks again.
Not sure how the block got off that little bit, but it was enough to wreak some havoc with the neck set. But as I said, all is well.

Dave Bagwill · Post by **Dave Bagwill** » Wed May 28, 2014 8:38 pm

Steve did a great job on getting the neck to feel just right for his hands. Today we glued on the heel cap and the headplate, and leveled and buffed the frets. Will start the finish next week on this and the Parlor guitar.

John Parchem · Post by **John Parchem** » Wed May 28, 2014 10:04 pm

The neck and fret board looks good.

Kevin in California · Post by **Kevin in California** » Wed May 28, 2014 10:40 pm

Coming right along. It will be a guitar soon.

Dave Bagwill · Post by **Dave Bagwill** » Fri May 30, 2014 4:53 pm

Drilled tuner holes after making a little jig for said purpose. Still need to clean up headplate and slots etc.

Acoustic Guitar Construction

Steve's KMG 000-12 kit

Re: Steve's KMG 000-12 kit

Re: Steve's KMG 000-12 kit

Re: Steve's KMG 000-12 kit

Re: Steve's KMG 000-12 kit

Re: Steve's KMG 000-12 kit

Re: Steve's KMG 000-12 kit

Re: Steve's KMG 000-12 kit