Acoustic Guitar Construction

Posted: **Sun Nov 30, 2014 5:04 pm**

Hey guys, I'm obviously way behind the times on this video demo.

I'm using a mega mold for the first time, with a Stew Mac Triple 0 kit I inherited.

When sanding the rim top, as in this video, is the bottom bout rim area and end block
sanded merely level, or does it receive the same angle as the upper area does for the
proper neck alignment (and the correct top radius)?

I feel pretty dense about this....

Thanks!

Kent H

Posted: **Sun Nov 30, 2014 6:16 pm**

Hi Kent,
Welcome!

Give the video a couple of plays and I am sure you'll get the drift of the process -- regarding your question, right at 1:47 of the video there is a text overlay that will clarify.

Posted: **Sun Nov 30, 2014 8:12 pm**

Thanks, Ken.

I thought that was the answer but, it was so simple it evaded me!

Thanks for this device!

Kent

Acoustic Guitar Construction

Preparing the top edge of the rim with the Mega Mold - Video

Re: Preparing the top edge of the rim with the Mega Mold - V

Re: Preparing the top edge of the rim with the Mega Mold - V

Re: Preparing the top edge of the rim with the Mega Mold - V