Slight gap...is this a problem?

[MarkAndrew1]

Way to go Mark! That is what you needed to do.

Kevin

Thanks Kevin! Trying to keep it moving!

[MarkAndrew1]

The other option would be to sand the rim down to the block and then cut the heel of the neck if it was too long. That would have been the easier fix. How deep is the guitar at the neck block now? Will it fit in a standard case? The route you chose is just fine, but there are other things to consider...like the depth of the case this guitar will go in. I make my dreadnoughts a bit deeper than standard...about .25" and they fit in a standard case just fine, so you are probably good to go.

Hi Tony,

I definitely thought of that as well. I will measure the exact depth but I believe
it's a couple 16ths shy of 4". Since, i haven't ordered the neck yet I was afraid
if I sanded too much then it would compromise the geometry of the angle and
God knows what else.

Anyway, thank you for the input and I will consider cutting the heel next time....