Binding issue

Selection of materials -- wood -- plastic -- routing the channels etc.
Post Reply
Kevin in California
Posts: 2799
Joined: Mon Dec 19, 2011 4:19 pm

Re: Binding issue

Post by Kevin in California » Mon Nov 26, 2012 10:54 am

Yeah just enough for it to ride on and no more...if it falls away, no harm done.
Top
Tim Benware
Posts: 1489
Joined: Thu Dec 22, 2011 1:22 pm
Location: Asheboro, NC

Re: Binding issue

Post by Tim Benware » Mon Nov 26, 2012 11:27 am

The flat area on mine is 1/4" and the slope is 3/8", the overall length is 5/8". The pad thickness is 3/16". Should I slope it back so it extends only a 1/4" from the cutting edge?
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Top
Post Reply

Return to “Bindings and Purfling”