Taylor Top Routing

[Go4aRyd]

I'm curious about the thickness of the top where it is routed... is it 1/16?

I will try to figure out a way to depth the route (sorry no gauge at present) else it will be awhile. I am planning to build a quick thickness gauge but that is way down on the list right now....

[Mark from Ashland]

Thanks. No hurry, of course, but I'm curious just how thin they make that wood. Assuming the top shown in your picture was about 0.01, that groove looks fairly deep.

[Go4aRyd]

Stopped by HF unexpectedly, so if you believe the mic, the top overall is abt 0.120 thick. At the center of the route channel, the top thins to abt 0.080.