tuner slots

[Carl Dickinson]

Kevin's advice is how I used to to it. Last time I made a jig for drilling the tuner holes, then routing the slots. Progressed the routing in about 5 depth changes. It went well. here's a bunch of pics.

slotjig1.jpg (326.4 KiB) Viewed 93 times

slotjig2.jpg (332.47 KiB) Viewed 93 times

slotjig3.jpg (363.93 KiB) Viewed 93 times

slotjig4.jpg (350.42 KiB) Viewed 93 times

slotjig5.jpg (273.57 KiB) Viewed 93 times

slotjig6.jpg (282.02 KiB) Viewed 93 times

slotjig7.jpg (270.49 KiB) Viewed 93 times

slotjig8.jpg (296.32 KiB) Viewed 93 times

slotjig9.jpg (304.26 KiB) Viewed 93 times

[peter havriluk]

Kevin, yup. That's my next step. After that - - - the 'ramps', I don't know the luthier's term for them - - - just mask, measure, and rasp carefully?

Thanks!

[Kenny Wiebusch]

Great looking jig Carl. One of these days I will try to make slots with square ends like high end Martins have. I wonder if they use a mortise and chisel bit?

[Herman]

That is a handy "one for all" jig. I do that with two jigs. One for the headstock shape and one for the position of the tuner holes. Here you should be sure the sides of the headstock sides are at the width shape in the first place. Otherwise the tuners wil not be in line. (Had that before ).
Herman

[Carl Dickinson]

It is made symetrical so that switching from side to side and indexing from the end of the headstock keeps the tuners in line.