Did I ruin this top

[Woodyok]

Hi All,
I wasn't sure if this should be in Rosettes or tops...anyway. I routed for my first Rosette with the StewMac Dremel base and rosette jig. I wanted to have the rosette just proud of the top so I wouldn't have to scrape too much. I accomplished that but when I turned the top over, this is what I saw.

Rosette 1.jpg (62.68 KiB) Viewed 1505 times

Rosette inside 2.jpg (65.73 KiB) Viewed 1505 times

Is this top ruined?

[ken cierp]

I believe it can be salvaged if you use epoxy -- I think that will unify the rosette and the thin sound board material.

[Tim Benware]

Good idea!

[Woodyok]

Unfortunately Ken the rosette is glued in with white glue. Unless you mean spread some epoxy on the inside?

[ken cierp]

OK I did not realize it was glued already -- no problem -- instead of those little sound hole reinforcements make one that goes all the way around the hole about an inch in diameter, or even a rectangle the ID should be just slightly smaller then the sound hole. Many classicals have this arrangement.

[Woodyok]

Thanks Ken,

I'll work on that. Great idea.

[Ken Hundley]

I agree, I was thinking to make a donut and glue on the inside surface, then lose the soundhole reinforcement braces.