A new OM about to be born
Re: A new OM about to be born
Wish you luck!!
-
John Parchem
- Posts: 2746
- Joined: Fri Dec 23, 2011 8:33 pm
- Location: Seattle
- Contact:
-
Carl Dickinson
- Posts: 149
- Joined: Thu Jun 28, 2018 2:36 pm
Re: A new OM about to be born
Go for it, Kevin!
-
Kevin in California
- Posts: 2795
- Joined: Mon Dec 19, 2011 4:19 pm
Re: A new OM about to be born
did the same thinner spray on the top 6 days ago and I'm level wet sanding with 800 grit.
The spraying worked here also. Cracks melted in.
The before picture shows where the cracks were. Slightly recessed or sunken lines from the lacquer filling in the cracks. The after picture shows it level and no cracks showing. I'm so happy.
The goal now is to complete this guitar by the first week of March so it can be taken to India.
The spraying worked here also. Cracks melted in.
The before picture shows where the cracks were. Slightly recessed or sunken lines from the lacquer filling in the cracks. The after picture shows it level and no cracks showing. I'm so happy.
The goal now is to complete this guitar by the first week of March so it can be taken to India.
- Attachments
-
- 20230211_092304.jpg (269.7 KiB) Viewed 1161 times
-
- 20230211_102330.jpg (205.28 KiB) Viewed 1161 times
Re: A new OM about to be born
Excellent, you lucky man
Herman
Herman
-
John Parchem
- Posts: 2746
- Joined: Fri Dec 23, 2011 8:33 pm
- Location: Seattle
- Contact:
Re: A new OM about to be born
Looking good. Hopefully they stay closed.
-
Kevin in California
- Posts: 2795
- Joined: Mon Dec 19, 2011 4:19 pm
Re: A new OM about to be born
Bad news.
Cracks are coming back.
I'll have to strip the top and a little on the sides and respray.
I gaVe it the old college try. Not this time I guess.
I'll start sanding it off in a few minutes.
Cracks are coming back.
I'll have to strip the top and a little on the sides and respray.
I gaVe it the old college try. Not this time I guess.
I'll start sanding it off in a few minutes.