Cocobolo O’M

[John J]

Thanks Herman. Here’s the top glued to the rims and ready for the back.

1FE3677B-7E90-4306-9E47-16ECDAC67B6C.jpeg (200.33 KiB) Viewed 1180 times

John

[John Parchem]

gorgeous work! So that pickup also has an internal microphone? Is there a way to mix between the under the saddle and the microphone?

[John J]

Thanks John. No that is a volume wheel. I didn’t want to risk getting finish on so it’s just taped out of the way.

John

[John J]

Box is about done. Just some finish sanding.

Ebony binding.

EECF4762-BA88-4DF5-A28E-8A280E17A49D.jpeg (167.42 KiB) Viewed 1162 times

Channel after the Teflon strip has been removed.

E4EEC1E2-D69A-4565-9D99-8EF44D1CA834.jpeg (237.64 KiB) Viewed 1162 times

Installing the purfling segments.

B4D4B947-0579-4248-93A5-4F91E08A4338.jpeg (310.56 KiB) Viewed 1162 times

E0D7656F-4EE4-4015-9EDB-9811E57D9DE6.jpeg (239.49 KiB) Viewed 1162 times

John

[John Parchem]

That purfling is way cool! I love the look.

[John J]

Thanks John.

Slow progress with the holidays, but I have done a bit. The neck attachment is similar to the Gore/Gilet bolt on. This differs in a couple of ways. The heel profile has to be at its final shape and sanded to a nearly finish state. The tenon is tapered from just underneath the top bolt hole to the bottom of the tenon. And since the fingerboard extension is not bolted down, but is free floating, it too has a slight taper to the underside.

3CB4FF86-4DA0-427A-B364-46346FC6A7F0.jpeg (269.38 KiB) Viewed 1110 times

08C068C7-AD7E-43F8-8B88-98340040207A.jpeg (268.02 KiB) Viewed 1110 times

Then I bolt it up and check for angle and center. Then I’ll use a new scalpel blade to scribe the heel outline on the body.

11881BE7-1B35-488B-BF51-BA4377622039.jpeg (262.21 KiB) Viewed 1110 times

3603FAF0-481F-4EC8-B909-32D90615B06B.jpeg (302.66 KiB) Viewed 1110 times

Then I oh so carefully rout out the heel pocket, finishing with a sharp chisel. I then deepen the neck pocket slightly from just below the top bolt hole to the bottom of the heel. This allows for movement.

14E777E3-7BBA-4805-9CFE-BA2FE7E45306.jpeg (282.36 KiB) Viewed 1110 times

D61E37CA-C677-4303-83D4-ED7C0D1BD038.jpeg (313.09 KiB) Viewed 1110 times

A final fitting and I can finish shape the neck.

0EFED431-13C6-4F39-AC8A-94D0C9903E4E.jpeg (308.28 KiB) Viewed 1110 times

[John Parchem]

Wow, That work looks really good. I like the neck design. Look forward to seeing this guitar complete.