John, that could be nice stuff. I always have some little dents around rosettes and bindings. Till now I fill them with thin CA. This glue could be more gelly.
Their accelerator on the other hand claims to cause no bubbles! tempting. Mine does accelerate a bit too strong and makes the glue cook!
Abalone soundhole ring too low!
-
Tim Benware
- Posts: 1489
- Joined: Thu Dec 22, 2011 1:22 pm
- Location: Asheboro, NC
Re: Abalone soundhole ring too low!
I use gluboost and it is a great product (a little expensive). The accelerator does not bubble the glue. I haven't used their gel yet. I have 2 thicknesses of Ca and their Finishing glue.John Link wrote:You folks may be interested in Gluboost Gel. It is apparently a new product for filling small gaps, as often come up in rosettes. I just got a blurb in the email about it.
https://gluboost.com/product/mastergel-ultra/
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Tim Benware
Creedmoor, NC
-
Tim Benware
- Posts: 1489
- Joined: Thu Dec 22, 2011 1:22 pm
- Location: Asheboro, NC
Re: Abalone soundhole ring too low!
It won't stay that way after the finish is applied if you sand it fine enough (220, 320)NeilG495 wrote:My concern is, if the glue is slightly high and I sand it, it will make it opaque and it might stay that way when the finish is sprayed on.
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Tim Benware
Creedmoor, NC
Re: Abalone soundhole ring too low!
Thanks a Tim, that’s the answer I was hoping for.Tim Benware wrote:It won't stay that way after the finish is applied if you sand it fine enough (220, 320)NeilG495 wrote:My concern is, if the glue is slightly high and I sand it, it will make it opaque and it might stay that way when the finish is sprayed on.