So I made a downdraft table out of odds 'n ends

Dave Bagwill · Post by **Dave Bagwill** » Wed Jul 25, 2018 4:47 pm

Eaasy to make, scrap matl's, works just fine.
I use the little belt-mounted remote so's I can keep the shop-vac on the other side of the door.

Dave Bagwill · Post by **Dave Bagwill** » Wed Jul 25, 2018 5:05 pm

Underneath

Kevin in California · Post by **Kevin in California** » Wed Jul 25, 2018 10:06 pm

Nice Dave. I should do something like that since i took the air cleaner out of the shop.

Tim Benware · Post by **Tim Benware** » Thu Jul 26, 2018 4:16 pm

Nice Dave. I've had the plans for one of these for years with the intent of making one and never got around to it. With my slow down now due to wife's retirement and or travel schedule i doubt it will get done.

Dave Bagwill · Post by **Dave Bagwill** » Fri Jul 27, 2018 12:23 am

What I can't do is caulk worth a damn....always sloppy.

Dave Bagwill · Post by **Dave Bagwill** » Mon Jul 30, 2018 8:11 pm

Haven't been able to use the shop for over a week. Medford, Oregon is surrounded by fires - we are north of Redding Ca and all that smoke comes to roost in our Rogue Valley (Medford) - last week Medford had the worst air quality in America. Made one's lungs hurt to be outside for any length of time.
My shop, alas, is not 'tight' so is no barrier to the smoke.
Or the 105 F temps.

Kevin in California · Post by **Kevin in California** » Tue Jul 31, 2018 10:53 am

Dave in our valley were are getting smoke from the Ferguson fire in Mariposa county. I can only imagine how bad it is there from the Carr fire.

Acoustic Guitar Construction

So I made a downdraft table out of odds 'n ends

So I made a downdraft table out of odds 'n ends

Re: So I made a downdraft table out of scrap

Re: So I made a downdraft table out of odds 'n ends

Re: So I made a downdraft table out of odds 'n ends

Re: So I made a downdraft table out of odds 'n ends

Re: So I made a downdraft table out of odds 'n ends

Re: So I made a downdraft table out of odds 'n ends