Self-explanatory I think?
After cutting on the bandsaw, the cut is usually so accurate that little touch-up is needed, either on the router table or on the drill sander.
The green sandpaper is 40-grit stick-em.
The rabbet that holds the brace material is 1/4" x 1/2" +/_ a wee bit to allow for the sandpaper.
The last pic does not show the brace on the jig, I just hold it on by hand since there is little to actually sand off. That is a bearing on the bottom of the drum.
Another radiusing idea
-
Dave Bagwill
- Posts: 5951
- Joined: Tue Dec 13, 2011 7:44 pm
Another radiusing idea
- Attachments
-
- DSC00001.JPG (137.67 KiB) Viewed 744 times
-
- DSC00007.JPG (140.06 KiB) Viewed 744 times
-
- DSC00008.JPG (117.76 KiB) Viewed 744 times
-
- DSC00009.JPG (151.08 KiB) Viewed 744 times
-
- DSC00010.JPG (149.08 KiB) Viewed 744 times
-
- DSC00012.JPG (105.07 KiB) Viewed 744 times
-
- DSC00014.JPG (126.24 KiB) Viewed 744 times
-Under permanent construction
-
Dave Bagwill
- Posts: 5951
- Joined: Tue Dec 13, 2011 7:44 pm
Re: Another radiusing idea
The bandsaw jig I got from this picture from somewhere:
- Attachments
-
- bandsawjig.jpg (51.24 KiB) Viewed 742 times
-Under permanent construction