Martin D41 kit

Show us how your current project is progressing
Post Reply
Andy C
Posts: 8
Joined: Tue Jul 05, 2016 9:08 pm

Martin D41 kit

Post by Andy C » Mon Aug 15, 2016 4:38 pm

Should I use your "8 3x5" to adjust my rim in the mold to sand the neck block angle or not.
I have already followed this part of your instructions and I need to know if I was correct by adjusting and sanding the angle on the top of the neck block or do I need to make changes before I glue the top on to my rim.
Thanks in advance,
Andy
Top
ken cierp
Posts: 3924
Joined: Tue Dec 13, 2011 11:23 pm

Re: Martin D41 build

Post by ken cierp » Mon Aug 15, 2016 11:42 pm

As long as the neck you are using has about an 88.5 degree cheek to finger board plane angle you should be fine.
Top
Andy C
Posts: 8
Joined: Tue Jul 05, 2016 9:08 pm

Re: Martin D41 kit

Post by Andy C » Tue Aug 16, 2016 4:41 pm

Thank you again !
Andy
Top
Post Reply

Return to “Construction logs”