Bending 1/4" all-thread

Things that matter and not -- Just keep it wholesome
Post Reply
Dave Bagwill
Posts: 5952
Joined: Tue Dec 13, 2011 7:44 pm

Bending 1/4" all-thread

Post by Dave Bagwill » Sun Apr 03, 2016 4:17 pm

Before I go out and buy a 3' length - can this stuff - 1/4" all-thread - be bent at a right angle, using a vise?
-Under permanent construction
Top
ken cierp
Posts: 3924
Joined: Tue Dec 13, 2011 11:23 pm

Re: Bending 1/4" all-thread

Post by ken cierp » Sun Apr 03, 2016 4:41 pm

50/50 it will snap off in a tight bend -- I think if you got it hot enough to start the bend with very little force you'd be OK.
Top
Dave Bagwill
Posts: 5952
Joined: Tue Dec 13, 2011 7:44 pm

Re: Bending 1/4" all-thread

Post by Dave Bagwill » Sun Apr 03, 2016 5:32 pm

Ok, thanks.
-Under permanent construction
Top
Herman
Posts: 1711
Joined: Sun Dec 30, 2012 1:20 pm
Location: Arnhem area, the Netherlands
Contact:
Contact Herman

Re: Bending 1/4" all-thread

Post by Herman » Mon Apr 04, 2016 6:48 am

Heat! Torch!
Top
Jim Ebert
Posts: 156
Joined: Thu Oct 30, 2014 11:22 am

Re: Bending 1/4" all-thread

Post by Jim Ebert » Mon Apr 04, 2016 9:11 am

Red Hot!
Top
Dave Bagwill
Posts: 5952
Joined: Tue Dec 13, 2011 7:44 pm

Re: Bending 1/4" all-thread

Post by Dave Bagwill » Mon Apr 04, 2016 12:08 pm

Not my hair dryer? :-)
-Under permanent construction
Top
Post Reply

Return to “"Shoot the Breeze"”