My New Thin Rip Sled

Tim Benware: Posts: 1489; Joined: Thu Dec 22, 2011 1:22 pm; Location: Asheboro, NC

Quote

Post by Tim Benware » Sat Mar 05, 2016 4:38 pm

I converted this old drill press table I wasn't using into a sled to rip brace stock with. I can get to less than a 1/2" piece remaining off the board.

Attachments

: DSCN0946 (640x480).jpg (250.41 KiB) Viewed 849 times

: DSCN0947 (640x480).jpg (286.8 KiB) Viewed 849 times

: DSCN0948 (640x480).jpg (251.66 KiB) Viewed 849 times

I've "Ben-Had" again!
Tim Benware
Creedmoor, NC