Kerfed lining jig works great
Kerfed lining jig works great
Finished up this jig and did a whole bunch of kerfed linings in no time. Based on the frets.com jig referenced here by Ken and also additions from the anzlf site and a couple of my own.
- Attachments
-
- image.jpeg (216.24 KiB) Viewed 876 times
-
- image.jpeg (183.31 KiB) Viewed 876 times
-
- image.jpeg (208.35 KiB) Viewed 876 times
JJ
Learning every day. And having fun doing it.
Learning every day. And having fun doing it.
-
Dave Bagwill
- Posts: 5951
- Joined: Tue Dec 13, 2011 7:44 pm
Re: Kerfed lining jig works great
That is quite the project and makes some nice-looking kerfing. How much do you charge?? :-)
-Under permanent construction
-
Tim Benware
- Posts: 1489
- Joined: Thu Dec 22, 2011 1:22 pm
- Location: Asheboro, NC
Re: Kerfed lining jig works great
Is it advancing it automatically?
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Tim Benware
Creedmoor, NC
Re: Kerfed lining jig works great
Yes Tim, it advances to the kerf spacing you set stopping just before the blade cuts the lining. When you pull it back it resets and you push towards the blade, advancing each push. You can actually move along quite rapidly. Alas not motorized (at least not yet).Tim Benware wrote:Is it advancing it automatically?
JJ
Learning every day. And having fun doing it.
Learning every day. And having fun doing it.