Sticker shock
-
- Posts: 5952
- Joined: Tue Dec 13, 2011 7:44 pm
Re: Sticker shock
Fortunately, time is not an issue for me, so taking some time to build a jig or tool is no biggie. But I would not turn away any of stewmac's stuff if someone left it on the front porch or something. :-)
-Under permanent construction
-
- Posts: 1489
- Joined: Thu Dec 22, 2011 1:22 pm
- Location: Asheboro, NC
Re: Sticker shock
Soon I may have some additional time on my hands to make some of my own jigs and tools. I have Don Teeter's two volumes and there are some great things to build/make in those books but I haven't had the time to do so yet.
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Tim Benware
Creedmoor, NC
-
- Posts: 5952
- Joined: Tue Dec 13, 2011 7:44 pm
Re: Sticker shock
What are some of the things in Teeter that you might try?
-Under permanent construction
-
- Posts: 1489
- Joined: Thu Dec 22, 2011 1:22 pm
- Location: Asheboro, NC
Re: Sticker shock
1. String Tension simulation jig
2. Bridge plate heater
3. Cross patch gadgets (used to line up side cracks for gluing and aligning patches)
4. Strut jacks
5. Slot jig for truss rods
He also has a great jig for bridge slotting but I need to study it a little further.
2. Bridge plate heater
3. Cross patch gadgets (used to line up side cracks for gluing and aligning patches)
4. Strut jacks
5. Slot jig for truss rods
He also has a great jig for bridge slotting but I need to study it a little further.
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Tim Benware
Creedmoor, NC
-
- Posts: 5952
- Joined: Tue Dec 13, 2011 7:44 pm
-
- Posts: 1489
- Joined: Thu Dec 22, 2011 1:22 pm
- Location: Asheboro, NC
Re: Sticker shock
V2 1. String Tension simulation jigdeadedith wrote:Tim - which volume of Teeter are those in?
Thanks
V2 2. Bridge plate heater
V1 3. Cross patch gadgets (used to line up side cracks for gluing and aligning patches)
V1 4. Strut jacks
V1 5. Slot jig for truss rods
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC
Tim Benware
Creedmoor, NC
-
- Posts: 5952
- Joined: Tue Dec 13, 2011 7:44 pm