OOPPPPS!!

ken cierp · Post by **ken cierp** » Sat Feb 21, 2015 12:18 pm

I assume you are planning to pre-bend the patch -- are you going to run the grain vertical or perpendicular?

Not sure why hiding the repair at this point is a real big concern -- you know the defect is there no matter what and if it a commission I personally would start over. The carbon fiber or fiber glass cloth would be a much more durable, predictable repair -- long term, its simply a better choice.

tim crain 54 · Post by **tim crain 54** » Sat Feb 21, 2015 2:12 pm

after much deliberation I decided to remove the back, this way I will have complete access no matter which repair direction I decide on. Now I'll know how to pull the back off a guitar if I need to again in the future. I was really pleased with my construction, the glue joints were really well fitted. That baby is built like a battle ship. I am leaning towards removing some of the side braces, bending and fitting a piece then laminating it to the sides. With the back off, I think that I can do a very clean job of it and be able to clamp the lamination securely with the body supported in the mold frame. The silver lining in this is that I think it highly unlikely that I will EVER make this mistake again!! After taking it apart, it certainly raised my level of confidence in the construction. I'll post my progress.

John Parchem · Post by **John Parchem** » Sat Feb 21, 2015 2:25 pm

Now it will be easier to fix, also looks like the back came off clean.

ken cierp · Post by **ken cierp** » Sat Feb 21, 2015 3:16 pm

Well there you go --- good thinking!!

tim crain 54 · Post by **tim crain 54** » Sat Feb 21, 2015 4:36 pm

Yeah the back came off really clean, just a small chip on the heal block so it should go back together pretty easily. This will certainly make the repair much easier and less noticeable when complete.

Herman · Post by **Herman** » Sun Feb 22, 2015 4:36 am

Yes Tim, that is courage! Who's the boss? Just take that back off! Well done.
Herman

Kent H · Post by **Kent H** » Sun Feb 22, 2015 2:55 pm

Nice Job!

I started working on guitars by rebuilding older Kays and Harmonys through pulling the backs and re-bracing utilizing the X style.

Hope I never have to do it with one of my "real builds" since I've progressed.

Knowing how to to pull a back still comes in handy. I'm renovating this old Kay/Oahu square neck and will move on to a Harwood as well.
Thankfully, binding hides the errors!

: 2014-09-13 14.50.05.jpg (95.37 KiB) Viewed 819 times

: 2014-08-12 19.04.53.jpg (99.1 KiB) Viewed 819 times

Acoustic Guitar Construction

OOPPPPS!!

Re: OOPPPPS!!

Re: OOPPPPS!!

Re: OOPPPPS!!

Re: OOPPPPS!!

Re: OOPPPPS!!

Re: OOPPPPS!!

Re: OOPPPPS!!