Greatest dust mask ever!!

[ken cierp]

Finally a dust mask that is effective, comfortable and most importantly does not cause my glasses to fog up. We did not get these at a wood worker's supplier but rather through a pharmaceutical supply. You will not be disappointed -- They are a quantum improvement over the typical crushed paper things

Pasturepharma NT-V2 Mask

[Dave Bagwill]

For those that don't wear glasses - eliminating the fog-up is a big deal, it can be really annoying. To the point that I will sometimes just take off the mask and continue working. Not good.
I'm gonna check it out.

[TonyinNYC]

A little piece of tape over the bridge of the nose to keep the mask attached to your nose will stop the fogging issue. At least, thats what I have heard. I dont wear glasses, but I intend to try it with my safety glasses next time I wear them with a mask. I often remove the glasses which is probably more dangerous than removing the mask!

[admin]

I am not going to do that, sounds like a PITA and I wear glasses -- Sorry Tony, my vote goes to a tool that is made for the job and really works, this mask has a foam seal/gasket.

[Brian Itzkin]

I prefer my mask, doesn't fog up safety glasses and the filter cartridges are replaceable. Not sure if regular glasses would fit over it though...

[ken cierp]

Our "Binks" respirators can be worn with glasses it has a much smaller very soft mouth/nose piece then the one Brian is wearing. However its an over kill for just dust (you could take out the cartridge I suppose?) -- with a particle mask like the one above you can fold it in half and stuff it in a pocket.

[Tim Benware]

I have allergies and the paper masks just don't close up enough to keep stuff out when floating around, so I use one very similar to Brian's. I have one for dust and one for spraying (different filters). It's actually pretty comfortable, at least to me.