The locking lever on the fence must have been an after thought or perhaps the wrong one? It does not work since its in the way if you adjust the fence aligning the work piece to the blade -- a real engineering DUH! The first two pixs are of the original and the simple lever I made to replace it.
For resaw you really need a table extension to keep the process safe. I cut my slices off the out side of the blank rather than up against the fence -- binding is eliminated and most importantly the blank rides the fence with a smooth square side for each subsequent cut.
To gage the thickness I have the little device from Rockler that Dave Bagwill turn me on to -- very cool.
I made a special pressure spring to keep the blank pressed against the fence. It rides and locks in the table slot via a little gadget I found at MLCS -- I think the pictures speak for themselves but if you have questions I'll try and explain.
