My KMG OM-28V Project
-
John Parchem
- Posts: 2746
- Joined: Fri Dec 23, 2011 8:33 pm
- Location: Seattle
- Contact:
Re: My KMG OM-28V Project
The spray looks good. I will look forward to seeing it buffed out.
-
Kevin in California
- Posts: 2799
- Joined: Mon Dec 19, 2011 4:19 pm
Re: My KMG OM-28V Project
Georgous!
-
Dennis in Anola
- Posts: 224
- Joined: Tue Mar 27, 2012 10:45 am
- Location: Anola Manitoba
Re: My KMG OM-28V Project
Here's the bridge clamped in place. You may notice the dark spot on the side through the sound hole, it's a compression dent that was steamed out as much as possible, then filled with wood dust & CA'd.
- Attachments
-
- BridgeClamp.jpg (175.02 KiB) Viewed 423 times
Just when you think you're getting ahead in the rat race, the rats get faster.
-
Dennis in Anola
- Posts: 224
- Joined: Tue Mar 27, 2012 10:45 am
- Location: Anola Manitoba
Re: My KMG OM-28V Project
The back & headstock after initial buffing. Once I'm finished handling it during construction & setup, I'll do a final hand buff job.
- Attachments
-
- BackBuff.jpg (199.21 KiB) Viewed 423 times
Just when you think you're getting ahead in the rat race, the rats get faster.
-
Dennis in Anola
- Posts: 224
- Joined: Tue Mar 27, 2012 10:45 am
- Location: Anola Manitoba
Re: My KMG OM-28V Project
Since this is a "vintage" guitar I installed Gotoh open back tuners in keeping with the theme. With a little luck I should hear what this instrument sounds like in a couple of days. So far I like the response when tapped, but there is no string tension on it yet.
- Attachments
-
- Gotoh.jpg (271.09 KiB) Viewed 421 times
Last edited by Dennis in Anola on Wed Nov 06, 2013 8:12 pm, edited 1 time in total.
Just when you think you're getting ahead in the rat race, the rats get faster.
-
Dave Bagwill
- Posts: 5951
- Joined: Tue Dec 13, 2011 7:44 pm
Re: My KMG OM-28V Project
That's a real nice look. I've been happy with the Gotoh's I've used.
-Under permanent construction