Clean bridge plate holes

Materials used - making - placing - gluing to the sound-board <-----<<< got to get this right!
Dave Bagwill
Posts: 5951
Joined: Tue Dec 13, 2011 7:44 pm

Re: Clean bridge plate holes

Post by Dave Bagwill » Mon Jun 10, 2013 5:25 pm

Lee! Welcome to the forum!

We have a few member from the U.K. and would like more. I myself am not from there, though I will drop a 'Bob's your uncle' upon occasion. :-)

Again, welcome.
-Under permanent construction

Tim Benware
Posts: 1489
Joined: Thu Dec 22, 2011 1:22 pm
Location: Asheboro, NC

Re: Clean bridge plate holes

Post by Tim Benware » Tue Jun 11, 2013 9:06 am

Lee in UK wrote:You just need a hard wood plate to go over the bridge plate and under the bolt heads to save getting those indentations in the plate from the bolt heads!
Yes, that happened when my old mind forgot to use it when gluing the bridge on but I usually use one. That wasn't the worse mistake I made this week, I'll post that one soon. I used to use the double stick tape method but however I was doing it made it hard for me to remove the backer afterwards. I don't know too much tape, too sticky, too much pressure.
I've "Ben-Had" again!
Tim Benware
Creedmoor, NC

Kevin in California
Posts: 2795
Joined: Mon Dec 19, 2011 4:19 pm

Re: Clean bridge plate holes

Post by Kevin in California » Tue Jun 11, 2013 3:50 pm

It seems I always forget to put a back up caul on the plate when I drill the holes....not this time.
Thanks for the reminder.

Kevin

Lee in UK
Posts: 11
Joined: Tue Jun 04, 2013 3:05 pm

Re: Clean bridge plate holes

Post by Lee in UK » Wed Jun 12, 2013 2:17 am

deadedith wrote:Lee! Welcome to the forum!

We have a few member from the U.K. and would like more. I myself am not from there, though I will drop a 'Bob's your uncle' upon occasion. :-)

Again, welcome.
Dave,

Thanks for the welcome! I am a complete newbie so can't promise to bring anything to the party other than numpty questions though!

Cheers
Lee

Dave Bagwill
Posts: 5951
Joined: Tue Dec 13, 2011 7:44 pm

Re: Clean bridge plate holes

Post by Dave Bagwill » Wed Jun 12, 2013 9:43 am

Questions are good, we were all noob's at one time!

I had to look it up: by 'look it up' I meant, of course, Google it, which always yields rock-solid and unquestionably true, true truths:
"Scotland's favourite word, according to a poll by BT Openreach, is numpty. Derived from "numps", an obsolete word for a stupid person, rather than the more obvious numbnuts or numbskull, the term implies general idiocy, often in my experience accompanied by windbaggery. Which explains why you will most often find it used in connection with members of the Scottish Parliament.

But numpty is a multi-purpose word, with great flexibility - my husband, for example, calls me "numpty-noo", an affectionate variation (I hope). With its plosive "p", it is a word capable of withstanding being hurled across football terraces - "Heid tha ball, ya useless nuuuuumpties!" - or gently remonstrating with a small child -"I know you didn't mean tae forget your gym kit, Hamish, but you'll look a right numpty in your vest and pants and nae mistake."

I get the gist :-)
-Under permanent construction

Post Reply