Tony and Kevin, thanks for your nice words. Kevin, I've used Emtech 6000 before, but not with the Zpoxy. I was using Target's HSF5100 and knew absolutely nothing about pore filling - was on my first guitar. Nor was I good with leveling the finish then. The guitar came out pretty well, and is now about 4 years old. I'm happy with the finish from that one. The only places that show wear are the black plastic bindings which were fairly sharp corners. There's some discoloration and wear along those edges. The rest is still pretty good. This time, I think, my leveling and pore filling have gone very well. I'm using cocobolo for bindings vice the plastic, and have rounded over the edges. Tony was a great help with his videos on sanding and leveling the finish, as was Todd Stock's set of videos on pore filling. It's going to be hard to wait the 100-150 hours after spraying the neck to put the guitar together.
Finally I got some time to make some progress on this thing. Work has been the busiest I've seen in 15 years here. Plus, I had to wait for the logo a very long time. Also, the thought of shaping the neck overwhelmed me at first.
I don't have any experience in doing this, so it was intimidating. But I just finally gritted it out and got it done.
First pic is the headstock after attaching it to the neck. Doing the routing was somewhat straightforward even though I thought I had goofed it up. Ebony dust has become my greatest friend. Andy DePaule emailed me a 1:1 scale of the inlay that was being sent, and recommended printing it, then super-gluing the paper to the headstock where I wanted it to go. That was probably better than trying to etch it out with an Xacto knife, but still was a bit hard to see. It worked, however, and looks pretty good.
First pic is the headstock being glued up, and the second is sanded, ready to spray tomorrow.
I had hoped for a totally black ebony head plate, but the wisping, smokey look going up the right side of this piece is catching my attention. I like it.
Here's the neck with a coat of Zpoxy pore filler, after being shaped the best that I can. I really like the wide neck heel. I capped it with some white fiber and a piece of cocobolo.
As I said, tomorrow and Monday, I'll spray the neck. Last Monday I had cataract surgery, and this Monday I'll have the 2nd eye done. I've taken the time between as a bit of vacation. My first in 13 months. While the finish sets up on the neck, I'll start sanding the body, and polishing it to be ready to fit things together.
One question for the real luthiers here. Do you recommend drilling the tuner holes before or after finishing the neck? If you do it first, do you wet sand any - and how do you protect the raw wood inside the holes?
Thanks for viewing,
Bob
